CreedFeed Community

CreedFeed Community (http://www.creedfeed.com/community/index.php)
-   Creed Talk (http://www.creedfeed.com/community/forumdisplay.php?f=4)
-   -   Box top slides back (http://www.creedfeed.com/community/showthread.php?t=14011)

RyanCaleb 09-20-2017 09:36 AM

Box top slides back
 
Hii...

I have made a sequence where the lid of a box slides back to reveal the contents inside. I did this by taking a picture of the box with the lid shut, moving the lid open a tiny bit, taking another picture, and so on until the lid was fully open. This took about 35 shots which were then sequenced in PTE. But even after playing with the transitions the effect is too jerky.
Is there a way in which I can keep the picture of the box without lid below a moving picture of the lid using animation?
Sorry if this is too simple a question but I have not done much with animation and masks, although I have used PTE for a few years. I have PTE 6.5.

Thanks!

I didn't find the right solution from the Internet.

References:-https://www.picturestoexe.com/forums/topic/14539-box-top-slides-back/

Promo videos


All times are GMT -4. The time now is 07:36 AM.

Powered by vBulletin Version 3.5.2
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2004 Steve Caponetto. All Rights Reserved.