View Single Post
Old 09-20-2017, 09:36 AM   #1
RyanCaleb
USER INFO »
Status: Silence Speaks
Posts: 59
Joined: Sep 2017
Currently: Offline
Box top slides back

Hii...

I have made a sequence where the lid of a box slides back to reveal the contents inside. I did this by taking a picture of the box with the lid shut, moving the lid open a tiny bit, taking another picture, and so on until the lid was fully open. This took about 35 shots which were then sequenced in PTE. But even after playing with the transitions the effect is too jerky.
Is there a way in which I can keep the picture of the box without lid below a moving picture of the lid using animation?
Sorry if this is too simple a question but I have not done much with animation and masks, although I have used PTE for a few years. I have PTE 6.5.

Thanks!

I didn't find the right solution from the Internet.

References:-https://www.picturestoexe.com/forums/topic/14539-box-top-slides-back/

Promo videos
Reply With Quote